Table of Contents
Advertisement
General Description
Emulation Module Layout
12
Emulation Module Layout
Figure 1 shows the layout of the M68EM05P18. W1 selects the
clock-signal source. Jumper header W2 controls the path of a target
reset.
Target connector J2 is the interface to a target system and uses a
separately purchased target cable assembly. When you install the
M68EM05P18 on the MMDS05, the target cable passes through the slit
in the station module enclosure. Connector J1 is used as a connection
to a logic analyzer. DIN connectors P1 and P2 connect the EM and a
development system platform board.
Location XU5 is the resident MCU. Switch SW1 enables or disables port
A mask options. A wirewrap area is at the lower right corner of the
M68EM05P18 board.
P1
W1
J1
Figure 1. M68EM05P18 Emulation Module
General Description
XU5
P2
J2
W2
SW1
WIRE
WRAP
AREA
M68EM05P18UM/D
MOTOROLA
Advertisement
Table of Contents
