Overview; Table 1-1. Startup Overview - Motorola PATX3070 Series Installation And Use Manual

Hardware Preparation and Installation
1

Overview

What you need to do...
Unpack the hardware.
Configure the hardware by setting jumpers on
the motherboard.
If necessary, install an I/O shield on the
motherboard.
Install the motherboard in the chassis.
Ensure that DIMM memory module(s) are
properly installed on the motherboard.
If applicable, install an AGP Graphics card on
the motherboard.
If applicable, install any PCI expansion cards on
the motherboard.
If applicable, install any ISA expansion cards on
the motherboard.
If applicable, install a SanDisk
CompactFlash module on the motherboard.
Connect a display terminal and any other
equipment you will be using.
Power up the system.
1-4
The following table lists the things you will need to do before you can use
this board and tells where to find the information you need to perform each
step. Be sure to read this entire chapter, including all cautions and
warnings, before you begin.

Table 1-1. Startup Overview

®
IDE
Refer to...
Unpacking Instructions on page 1-5
PATX3070 Motherboard Preparation on page
1-6
I/O Shield on page 1-14
Motherboard on page 1-15
DIMM Memory on page 1-18
AGP Graphics Slot on page 1-19
PCI Expansion Cards on page 1-20
ISA Module(s) on page 1-21
SanDisk IDE CompactFlash on page 1-22
Connection to Peripherals on page 1-25
For more information on optional devices and
equipment, refer to the documentation
provided with the equipment.
Chapter 2, BIOS Self-Test and Setup
Computer Group Literature Center Web Site