Toshiba Carrier RAV-SP180AT2-UL Service Manual page 89

11-1-2. RAV-SP240AT2-UL
No. Part name
Common
procedure
Be sure to put on the gloves at working time;
otherwise an injury may be caused by a part,
etc.
1. Detachment
1) Stop operation of the air conditioner and then
2) Remove the front panel.
3) Remove the power wire and indoor/outdoor
4) Remove the top plate.
2. Attachment
1) Attach the top plate.
2) Connect the power supply wire and the
Using bundling band on the market, be sure to
fix the power wire and indoor/outdoor
connecting wire along the crossover pipe so that
they do not come to contact with the compressor,
valve at gas side, pipe at gas side and
discharge pipe.
3) Attach the front panel.
Procedure
CAUTION
turn off switch of the breaker.
(Hexagonal screw M4, 10 mm, 2 pcs.)
∗ After removing screws, remove the front
panel while pulling it downward.
connecting wire from the cord clamp and the
terminals.
(Hexagonal screw M4, 10 mm, 5 pcs.)
(Hexagonal screw M4, 10 mm, 5 pcs.)
In this time, insert the fin guard of rear side
between the top plate and the heat exchanger
(Rear side).
indoor/outdoor connecting wire to the terminal
and fix it with cord clamp.
CAUTION
(Hexagonal screw M4, 10 mm, 2 pcs.)
– 89 –
Remarks
Front panel
Top plate
Insert the fin guard of rear side between
the top plate and the heat exchanger
(at rear side).