Toshiba Carrier RAV-SP180AT2-UL Service Manual page 87

No. Part name
Fan motor 1) Perform works of Detachment 1 of
2) Take off the flange nut fixing the fan motor and the propeller.
3) Remove the propeller fan.
4) Disconnect the connector for fan motor from the inverter.
5) Take off the fixing screws (2 pcs.) holding by hands so that
NOTE:
Tighten the flange nut with torque 4.9Nm (50kgf/cm).
Compressor 1) Perform works of Detachment 1 of
2) Discharge refrigerant gas.
3) Remove the partition plate. (M4, 8 mm, 3 pcs.)
4) Remove the noise-insulator.
5) Remove the terminal covers of the compressor, and discon-
6) Remove pipes connected to the compressor with a burner.
Pay attention to that flame does not involve 4-way valve,
PMV, pressure SW, or fusible plug.
(If doing so, a malfunction may be caused.)
7) Remove the side cabinet (Left). (M4, 8 mm, 3 pcs.)
8) Take off the fixing screws of the bottom plate and heat
9) Take off the fixing screws of the valve clamping plate to the
10) Pull upward he refrigerating cycle.
11) Take off nut fixing the compressor to the bottom place.
When reconnecting the lead wires to the compressor
terminals after replacement of the compressor, be sure to
caulk the Faston terminal without loosening.
Procedure
• Turning it clockwise, the flange nut can be loosened.
(To tighten the flange nut, turn counterclockwise.)
the fan motor does not fall.
nect lead wires of the compressor and the compressor
thermo assembly from the terminal.
CAUTION
exchanger. (M4, 8 mm)
bottom plate. (M4, 8 mm, 1 pc.)
CAUTION
and .
, , and
– 87 –
Remarks
Flange nut Flange nut Flange nut
Loosen the nut by Loosen the nut by Loosen the nut by
turning clockwise turning clockwise turning clockwise
Propeller fan Propeller fan Propeller fan
Fan motor Fan motor Fan motor
.
Partition plate Partition plate Partition plate
Compressor lead Compressor lead Compressor lead
Case thermo Case thermo Case thermo
Remove Remove Remove
(Discharge pipe) (Discharge pipe) (Discharge pipe)
Pressure Pressure Pressure
switch switch switch
Remove Remove Remove
(Suction pipe) (Suction pipe) (Suction pipe)
Valve Valve Valve
support board support board support board
Compressor bolt Compressor bolt Compressor bolt
(3 pcs.) (3 pcs.) (3 pcs.)
Fusible plug Fusible plug Fusible plug