Toshiba Carrier RAV-SP180AT2-UL Service Manual page 100

No. Part name
1. Detachment
Discharge
port cabinet
1) Perform work of Detachment 1 of
2) Remove screws for the discharge port
3) Remove screws for the discharge port
4) Remove screws for the discharge cabinet
5) Remove screw for the discharge cabinet
6) Remove screws for the discharge port
Side cabinet 1) Perform work of Detachment 1 of
2) Remove the screws which fix the inverter
3) Take off screws that fix the wiring division
4) Remove the screws for the side cabinet
6) Remove screws for the side cabinet and
6) Remove screw for the side cabinet and the
7) Remove screws for the side cabinet and
Inverter 1) Perform work of Detachment 1 of
protective
2) Take off screw which fixes the inverter
cover
Procedure
cabinet and the partition board.
(M4, 8 mm, 4 pcs.)
cabinet and the bottom plate.
(Hexagonal screw M4, 10 mm, 2 pcs.)
and the motor base. (M4, 8 mm, 2 pcs.)
and the heat exchanger. (M4, 8 mm, 1 pc.)
cabinet and the fin guard.
(Hexagonal screw M4, 10 mm, 2 pcs.)
assembly and the side cabinet.
(M4, 8 mm, 2 pcs.)
panel and the side cabinet.
and the valve fixing plate.
(M4, 8 mm, 2 pcs.)
the piping panel (Rear).
(Hexagonal screw M4, 10 mm, 2 pcs.)
bottom plate.
(Hexagonal screw M4, 10 mm, 1 pc.)
the fin guard (Heat exchanger).
(Hexagonal screw M4, 10 mm, 5 pcs.)
assembly and the inverter protective cover.
(M4, 8 mm, 1 pc.)
.
Heat exchanger
Fin guard
.
Inverter assembly Inverter assembly Inverter assembly
Valve fixing plate Valve fixing plate Valve fixing plate
.
Inverter protective cover
– 100 –
Remarks
Motor base Partition board
Discharge
port cabinet
Side cabinet Side cabinet Side cabinet