Copying Problems - Epson WorkForce 435 User Manual

Noise After Ink Installation
• The first time you install ink cartridges, your product must prime its print head for about 2 1/2
minutes. Wait until the process is complete (the
your product, or it may prime improperly and use excess ink the next time you turn it on.
If the product stops moving or making noise, but the
minutes, turn off your product. If the light is still flashing when you turn it back on, contact
Epson.
• Turn off your product, then make sure the ink cartridges are inserted completely and the ink
cartridge cover is closed completely. Also make sure no packing material remains in the
product. Wait a moment, then turn the product back on to clear the error.
Software Installation Problems
• If you're installing the product on a network, follow the instructions on the Start Here sheet.
• If you're installing the product using a USB cable, make sure your product is turned on and
the cable is securely connected at both ends. If you still have problems, disconnect the cable
and carefully follow the software installation instructions on the Start Here sheet and on the
screen. Also make sure your system meets the requirements.
• Close your other programs, including any screen savers and virus protection software, and
install the software again.
• In Windows, make sure your product is selected as the default printer and that the correct port
is shown in the printer properties.
• If you see an error message or your software doesn't install correctly in Windows, you may
not have software installation privileges. Contact your System Administrator.
• If you installed the product using a USB cable, make sure the USB Controller is working
properly in Device Manager. See your Windows help system for details. If it's not working,
contact your computer manufacturer.
• If you connected the USB cable temporarily when setting up your product for wireless use,
remember to disconnect the cable after setup.

Copying Problems

Nothing Prints, Even Though the On Light Is On
Printing Noise Occurs, Even Though Nothing Prints
Noise Occurs When the Product Sits for a While
Edges Are Cropped
Nothing Prints, Even Though the
• Run a product check. If the test page prints, make sure your software is installed correctly.
• Printing stops when an ink cartridge is expended. If a color cartridge is expended, you may be
able to continue printing temporarily with black ink. If a black cartridge is expended, you
must replace it to continue printing.
144
On
Light Is On
On light stops flashing) before you turn off
On light is still flashing after 5