Epson WorkForce 435 User Manual page 140

Note:
Always turn off the product using the
flashing before unplugging the product or cutting off power to the electrical outlet.
2. Remove all the paper.
3. Close the paper support and output tray.
4. Lift up the scanner unit and check that the ink cartridge holder is all the way to the right (the
home position). If necessary, turn on the product, wait until the print head locks into the home
position, then turn it off again.
5. Fasten the ink cartridge holder to the case using tape. Leave the ink cartridges installed to
avoid damaging the product.
Caution:
Do not place tape on the flat, white cable inside the product; otherwise you may damage your
product.
6. Lower the scanner unit.
7. Unplug all the connected cables.
8. Pack the product in its original box or one of a similar size using protective material to keep it
from moving inside the box.
9. Keep the product level during transportation to prevent damage.
10. After unpacking your product, remove the tape securing the ink cartridge holder.
If print quality has declined when you print again in a new location, clean and align the print head.
140
On button, and wait until the On light stops