Table of Contents
Advertisement
32 www.aeg.com
50 mm
13.5 Electrical installation
The manufacturer is not responsi-
ble if you do not follow the safety
precautions from the chapter
"Safety information".
60 mm
60 mm
A
B
13.4 The anti-tilt protection
1.
Set the correct height and area for
the appliance before you attach the
anti-tilt protection.
50 mm
2.
The anti-tilt protection has two parts
(A+B). You can find the anti-tilt pro-
A
tection (B) on the right or left side of
the rear wall of the appliance (See
fig. 1). You must install the anti-tilt
protection (A) on the wall. The dis-
tance of the hole of the anti-tilt pro-
tection (A) from the floor is about
816 mm. Make sure you install the
anti-tilt protection (A) at the correct
height. Screw it into the solid materi-
al or use applicable reinforcement.
Check that the anti-tilt protection fits
3.
minimum 20 mm into the hole in rear
wall of the appliance (B) when you
push the appliance (See fig. 2). Put
the appliance in the middle of the
space between the cupboards. If the
space is larger than the width of the
appliance, you must adjust the side
measurement. Make sure that the
surface behind the appliance is
smooth.
This appliance is supplied without a
main plug or a main cable.
Applicable cable types: H07 RN-F, H05
RN-F, H05 RRF, H05 VV-F, H05 V2V2-F
(T90), H05 BB-F.
CAUTION!
You must install the anti-tilt pro-
tection. If you do not install it,
the appliance can tilt.
Make sure you install the anti-tilt
protection at the correct height.
Hide quick links:
Advertisement
Table of Contents
