Outer Case; Back Panel; Stirrer Cover; Rtd (Resistance Thermal Device) - Amana ACE208 Service Manual

Disassembly
To avoid the risk of electrical shock, personal injury, or death, disconnect power to oven and discharge capacitors
before following any disassembly procedure.

Outer Case

1. Remove screws securing outer case to chassis, see
illustration below.
2. Slide outer case back and lift off.
3. Reassemble outer case in reverse order.

Back Panel

1. Remove outer case.
2. Remove screws securing back panel.
3. Reassemble back panel in reverse order.
Outer
Case

Stirrer Cover

1. See "Component Location" Figure 4, for location.
2. Unplug oven before removing stirrer cover to access
stirrer assembly.
3. Loosen screw securing stirrer cover mounting clip
and rotate clip to the side.
4. Slowly lower front of stirrer cover, then pull gently
towards front of unit to release cover.
5. Replace stirrer cover by fitting stirrer blade on stirrer
insert. Place back of stirrer cover into place, align
stirrer insert onto stirrer shaft. Lift front of cover into
position, rotate mounting clip into position, tighten
screw.
!
CAUTION
If mounting clip is loose arcing will occur.
RS2220002 Rev. 0
!
WARNING
Back
Panel
Mounting
Screw

RTD (Resistance Thermal Device)

1. See "Component Location" Figure 4, for location.
2. Remove outer case.
3. Disconnect RTD harness connector.
4. Remove mounting screw located inside oven.
5. Lift RTD from top of the oven.
6. Reassemble RTD in reverse order.

Top Touch Panel Assembly

1. See "Component Location" Figure 1, for location.
2. Remove outer case.
3. Disconnect all wire connectors at display board.
4. Remove screws securing top touch panel to unit.
5. Remove screws securing display board to top touch
panel assembly.
6. Reassemble touch panel in reverse order.
32
Stirrer Shaft
Stirrer Blade
Stirrer Insert
Stirrer Cover
Stirrer Cover
Mounting Clip