Fan Blade; Transformer; Capacitor; Heater Box - Amana ACE208 Service Manual

Disassembly
To avoid the risk of electrical shock, personal injury, or death, disconnect power to oven and discharge capacitors
before following any disassembly procedure.

Fan Blade

1. Pull blade off shaft.
2. When reinstalling blade, push blade on shaft and
rotate to insure clearance between fan blade and
motor mounting bolt.

Transformer

1. See "Component Location" Figure 3, for location.
2. Remove outer case and back panel.
3. Remove screws securing transformer to chassis.
4. Pry upward and back to release transformer from
chassis.
5. Remove wire connections from transformer.
NOTE: When placing transformer back into chassis.
Front portion of transformer must slide into
base pan tab.
6. Reassemble transformer in reverse order.

Capacitor

1. See "Component Location" Figure 2, for location.
2. Remove outer case and back panel.
3. Discharge capacitor and remove wires from
terminals.
4. Remove capacitor bracket mounting screw.
5. Reassemble capacitor in reverse order.
NOTE: Capacitor case must be installed into indent in
back panel.
!
WARNING

Heater Box

1. See "Component Location" Figure 3, for location.
2. Remove outer case and back panel.
3. Remove wires connected to heating elements,
convection fan, and control thermal cutout.
4. Remove screws securing heater box.
5. Slide heater box sideways from chassis.
6. Reassemble heater box in reverse order

Heating Elements

1. See "Component Location" Figure 5, for location.
2. Remove outer case and back panel.
3. Remove heater box.
4. Remove screws securing heater assembly to heater
box.
5. Reassemble heating element in reverse order.
NOTE: Center heating element around convection fan
blade.

Convection Fan and Motor

1. See "Component Location" Figure 5, for location.
2. Remove outer case and back panel.
3. Remove heater box.
4. Remove left handed threaded nut on fan blade, and
slide fan off.
5. Remove screws securing convection motor to heater
box.
6. Reassemble convection motor in reverse order.

Fuse

1. See "Component Location" Figure 2, for location.
2. Remove outer case.
3. Replace fuse and reassemble in reverse order.
35 RS2220002 Rev. 0