Outer Case; Back Panel; Interlock Switch Module; Stirrer Motor And Antenna Gears - Amana AMH20 Service Manual

Disassembly
To avoid the risk of electrical shock, personal injury, or death, disconnect power to oven and discharge capacitors
before following any disassembly procedure.

Outer Case

1. Remove screws securing outer flue, located on the
back of the unit.
2. Remove screws securing outer case to chassis, see
illustration below.
3. Slide outer case back and lift off.
4. Reverse procedure to reassemble.

Back Panel

1. Remove outer case, see "Outer Case" procedure.
2. Remove screws securing inner flue, located on the
back of the unit.
3. Remove screws securing back panel.
4. Reverse procedure to reassemble.
©2006 Maytag Services
!
WARNING

Interlock Switch Module

1. See "Component Location" Figure 2, for location.
2. Remove outer case, see "Outer Case" procedure.
3. Disconnect wiring from interlock switch assembly.
4. Remove mounting screws securing interlock switch.
5. When replacing assembly, all wires must be
connected before operating oven.
NOTE: When the line fuse is blown, interlock switch
module must be replaced.
Adjustment
1. To adjust interlock switch assembly, close door.
2. Loosen bottom and top screw on the interlock switch
assembly, allowing switch assembly to move in or out.
3. With door closed, push forward on interlock assembly
to engage door latch. Then pull back on interlock
assembly until door is "snug" against front oven cavity
and tighten bottom screw first, then top screw.
4. Door will remain latched when proper adjustment is
made.
NOTE: If door is not properly adjusted display will
indicate DOOR when the door is closed.

Stirrer Motor and Antenna Gears

1. Unplug oven and place unit on its side.
2. Removing screw securing bottom access panel.
3. Remove screws securing stirrer motor to chassis.
4. Remove retainer clip securing antenna gear to
antenna shaft.
5. Reverse procedure to reassemble.
16023463
7
8
2
4
3
5
27