Table of Contents
Advertisement
Disassembly
!
Bottom Shelf
NOTE: The tray is sealed in place with Silicone Rubber.
This type of sealant releases acetic acid and needs
curing. The unit should not be used for minimum of one
hour after application.
1. Unplug oven from outlet.
2. Open door and using a thin bladed knife, cut seal
along edges and remove pieces from unit.
3. Remove any sealant residue and thoroughly clean
sump area using a mild detergent.
4. Clean oven cavity bottom where new RTV sealant will
make contact using mineral spirits or any
nonflammable de-greasing solvent.
NOTE: Detergents, soap, and water are not sufficient to
remove oil and grease.
5. Place new tray into unit and seal in place.
6. Allow RTV sealant to cure one hour before using.
Grease Shield
1. Unplug oven before removing grease shield to
stop antenna from rotating.
2. Remove shield by placing thumbs in front of shield.
Press firmly toward back and carefully lower front of
shield away from antenna. Pull shield forward, out of
back slots and out of oven.
3. Replace grease shield by fitting tabs into slots at top
of oven back. Lift and press front of shield until
shield snaps into place.
Outer Case
1. Remove screws in side and back.
2. Slide outer case back and lift off.
RS5320014 Rev. 0
WARNING
To avoid risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.
Top Touch Panel Assembly
1. Remove outer case.
2. Remove ribbon cable from low voltage circuit board.
3. Remove screws and lift out.
Ribbon
Cable
Connector -Side Keypad
Split in ribbon cable to the right
as facing the front of the unit.
L.V. Board
Connector - Top Keypad
Split in ribbon cable to the right
as facing the front of the unit.
Side Touch Panel Assembly
1. Remove outer case.
2. Remove ribbon cable from low voltage circuit board.
3. Remove low voltage circuit board.
4. Loosen outer case trim.
5. Remove mounting screw(s).
6. Tilt side touch panel away from oven, release bottom
mounting tabs (some models), and remove panel.
Low Voltage Circuit Board
1. Remove outer case.
2. Disconnect ribbon cables.
3. Disconnect connector from back of circuit board.
4. Squeeze clips together to depress the four standoffs
and lift board out.
32
Split
End
Advertisement
Table of Contents
