Disassembly; Latch Handle; Door; Outer Case - Amana DQ22HS Service Manual

Disassembly

!

Latch Handle

The latch handle is removed by loosening the two set
screws (3/32 inch allen screws), one located to the left of
the latch and one located on the bottom of the latch
handle.
NOTE: If the set screws are removed, the set screw
with the flat end must be used in the bottom of
the latch handle.
NOTE: When replacing door handle, tighten side set
screw first.

Door

1. Remove latch handle.
2. Remove outer door ring assembly from inner door
ring by removing 10 y-drive screws.
NOTE: When reinstalling outer door, tighten screws in
pattern as shown above.
Outer Door
Outer Door Assembly
The outer door assembly consists of the outer door,
outer window, and lens retainer. These components are
available only as a complete assembly.
RS2220001 Rev. 2
WARNING
y
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.

Inner Door Ring Assembly

1. Remove latch handle.
2. Remove outer door assembly.
3. Remove 5 hinge screws securing inner door ring
assembly.
Inner Door Ring Assembly
The door ring assembly consists of the inner door ring,
the inner door panel, and latch assembly. These
components are available only as a complete assembly.

Hinge

1. Remove outer case.
2. Remove door latch handle.
3. Remove outer door assembly.
4. Remove nine hinge mounting screws from hinge (five
on front, 4 on side).
NOTE: Reinstall foam gasket on side of hinge when
reinstalling.
5. When reinstalling hinge mounting screws, keep the
side screws loose and the front screws tight, close
door, press door against oven on the hinge side and
tighten side hinge mounting screws in the sequence
shown below.
3
2
4
1
30