Display Module; Magnetron; Magnetron, Control, And Fan Thermal Cutout (Tco); Triacs - Amana ACE208 Service Manual

Disassembly
To avoid the risk of electrical shock, personal injury, or death, disconnect power to oven and discharge capacitors
before following any disassembly procedure.

Display Module

1. See "Component Location" Figure 1, for location.
2. Remove outer case.
3. Remove top touch panel, see Top Touch Panel
Assembly procedure.
4. Reassemble display module in reverse order.

Magnetron

1. See "Component Location" Figure 3, for location.
2. Remove outer case.
3. Remove screws securing magnetron inlet cover and
remove cover.
4. Remove screws securing waveguide duct.
5. Remove wires from magnetron.
6. Remove allen screws securing magnetron thermal
cutout bracket to magnetron.
7. Remove magnetron mounting nuts and remove front
magnetron cover bracket..
8. Remove magnetron.
9. When replacing magnetron, verify wire mesh gasket
is reinstalled properly.
NOTE: When reinstalling magnetron, slide air baffle
inside magnetron before mounting magnetron in
place.
NOTE: Place front magnetron cover bracket in place
before securing magnetron.
Magnetron, Control, and Fan Thermal
Cutout (TCO)
1. See "Component Location" Figure 3, for location.
2. Remove outer case.
3. Remove wiring from selected thermal cutout.
4. Remove screws securing thermal cutout.
5. Reassemble thermal cutout in reverse order.
RS2220002 Rev. 0
!
WARNING

Triacs

1. See "Component Location" Figure 1, for location.
2. Remove outer case and back panel.
3. Remove wires from terminals of selected triac.
4. Remove screws securing triac to chassis.
5. Reassemble triac in reverse order.

Microwave Blower Wheel and Motor

1. Remove outer case and back panel.
2. Remove wiring from blower motor terminals.
3. Remove screws securing blower assembly to
bracket.
4. Remove assembly from oven.
5. Loosen allen set screw securing blower wheel to
motor shaft.
6. Remove blower wheel.
7. Remove screws securing motor to scroll.
8. Reassemble blower wheel and motor in reverse
order.
NOTE: When reinstalling blower wheel, push blower
wheel on shaft, tighten, and rotate to insure
clearance between blower wheel, and blower
housing.
34
Fan Blade
Motor
Housing
Wheel
Blower Assembly