Table of Contents
Advertisement
S
S
UPER
ERVER 1027R-72RFTP User's Manual
1-2
Serverboard Features
At the heart of the SuperServer 1027R-72RFTP lies the X9DRW-7TPF, a dual pro-
cessor serverboard based on the Intel® C602 chipset. Below are the main features
of the serverboard. (See Figure 1-1 for a block diagram of the chipset).
Processors
The X9DRW-7TPF supports single or dual Intel® E5-2600 Series (Socket R) pro-
cessors in LGA 2011 sockets. Please refer to our web site for a complete listing of
supported processors (www.supermicro.com).
Memory
The X9DRW-7TPF features 16 DIMM slots that can support up to 512 GB of
ECC RDIMM DDR3-1600/1333/1066/800 SDRAM or 128GB of ECC UDIMM type
memory. Please refer to Chapter 5 for installing memory.
Onboard SAS
A SAS controller is integrated into the chipset to support eight SAS 2.0 ports. The
hot-swap SAS drives are connected to a backplane that provides power, bus ter-
mination and configuration settings. Unless otherwise stated, SAS is used in this
server by default.
Note: RAID 0, 1, 5, 6, 10, 50 and 60 is supported. Refer to the following ftp site
for setup guidelines:
<ftp://ftp.supermicro.com/driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf>.
Onboard Serial ATA
An on-chip SATA controller is integrated into the X9DRW-7TPF to provide a six-
port, SATA subsystem (two SATA 3.0 ports and four SATA 2.0 ports), which is
RAID 0, 1, 5 and 10 supported (RAID 5 is supported with Windows OS only).
Note: You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
Rear I/O Ports
The color-coded I/O ports include one COM port, a VGA (monitor) port, two USB
2.0 ports, PS/2 mouse and keyboard ports, two 1 Gb LAN ports, two 10Gb SFP+
LAN ports and one dedicated IPMI LAN port.
1-2
Advertisement
Table of Contents
