Bypass Copying; Bypass Copying - Toshiba e-STUDIO 520 Operator's Manual

6. Bypass Copying

Bypass copying

When you want to make copies on OHP film, sticker labels, or non-standard size paper, place the sheets
of paper on the bypass tray. Bypass copying is also recommended for copying on standard size paper
which is not in any of the drawers.
The following basic features can be used without specifying the paper size.
• Book Center Erase, XY Zoom, Cover Sheet, Sheet Insertion, Job Build, Image Direction,
Book Tablet and Inserter
The following features can be used by specifying the paper size in addition to the basic features.
• Image Shift, Edge Erase, Dual Page, 2IN1/4IN1, Magazine Sort, Editing, Time Stamp, Page Number
and Tab Paper in the Edit menu
• Rotate Sort, Hole Punch and Magazine Sort in the Sort Options menu
• "1 -> 2 Duplex", "2 -> 2 Duplex" and "Book -> 2" in the Duplex Modes menu
• APS and AMS in the Enlargement/Reduction menu
To carry out bypass copying, open the bypass tray.
The operating procedure of bypass copying differs depending on the paper size used. See the corre-
sponding page for the operating procedure of each size. The table below shows these pages.
Paper size
Standard size
Others (Non-standard size)
To set tab paper on the bypass tray, see
• Bypass copying stops when the paper placed on the bypass tray runs out during copying, even if the
same size paper is in any of the drawers. Copying is resumed when paper is supplied to the bypass
tray.
• When bypass copying has completed, the [FUNCTION CLEAR] button on the control panel blinks.
Press this button to switch it to default copying using the drawers. (Bypass copying is automatically
canceled after a certain period by automatic function clearing without the need to press the [FUNC-
TION CLEAR] button. The bypass copying returns to default copying using the drawers after this auto-
matic function clearing.)
LD, LT, LG, ST-R
Other than the above
P.175 "Setting tab paper on the bypass tray".
Procedure
P.76
P.78
P.80
2
75