Regency Horizon HZ42E-NG Owners & Installation Manual page 50

INSTALLATION
7) Secure each bracket with 4 screws in locations shown below.
Top of lower
faceplate
Screw locations.
8) Install the inner slide removed from Step 4 to the bracket.
Note: Installation locations of the slide are different for the HZ42 and
HZ42ST - read instructions carefully.
HZ42 - install slider on
this side of the bracket.
HZ42 - Install slider with fl at
side facing outward
-secure with 2 screws
in locations shown.
HZ42ST - install
slider on this side of the
bracket.
50
HZ42ST - install slider with fl at
side facing inwards
-secure with 2 screws in
locations shown.
10) With brackets and inner slides attached to the lower faceplate
panel - guide the lower faceplate panel into the outer slides located
in the bottom part of the unit. See inset.
Push in until fl ush with upper faceplate.
To adjust the space between the upper faceplate and the lower
faceplate panel - see step 2.
11) Final installation of faceplate on HZ42 unit
Note: Two faceplates need to be installed on the HZ42 ST unit.
HZ42E Regency Horizon™ Gas Fireplace