Regency Horizon HZ42E-NG Owners & Installation Manual page 44

INSTALLATION
10) Feed the plug wiring through the opening in the
fi rebox - secure light assembly mounting plate and gasket
with 4 screws from the cover plate in step 9.
11) Remove the 2 cover plates and gaskets located in the lower front of the
fi rebox by removing 4 screws from each plate - see below.
Discard cover plates and gaskets - keep the screws.
12) Remove one screw securing the socket end of the diffuser and
separate the 2 parts - as shown below.
13) Remove the amber glass - by sliding out.
44
14) Place gasket over the inside perimeter of the light diffuser box.
15) From outside the fi rebox -Install light assembly box and
gasket into opening created from the removal of the cover plates
open end up - as shown below.
16) Secure the light diffuser in place with the 4 screws set aside from
the cover plates.
17) Slide amber glass into light diffuser to reinstall.
18) Install bulb into the socket end of assembly - as shown below.
Note: Oils from hands will shorten the life of the bulbs,
do not handle bulbs with bare hands.
Screws secured from outside
the fi rebox.
HZ42E Regency Horizon™ Gas Fireplace