Configuring Mpls O-Uni Bandwidth - Cisco CRS Configuration Manual

Configuring MPLS O-UNI Bandwidth

Command or Action
Step 2
rsvp
Example:
RP/0/RP0/CPU0:router(config)# rsvp
Step 3 interface type interface-path-id
Example:
RP/0/RP0/CPU0:router(config-rsvp)#
interface pos 0/2/0/0
Step 4
bandwidth total-bandwidth max-flow sub-pool
sub-pool-bw
Example:
RP/0/RP0/CPU0:router(config-rsvp-if)#
bandwidth 1000 100 sub-pool 150
Step 5 Use the commit or end command.
Related Topics
Differentiated Services Traffic Engineering, on page 172
Bandwidth Configuration (MAM): Example, on page 146
Bandwidth Configuration (RDM): Example, on page 147
Configuring MPLS O-UNI Bandwidth
For this application you do not need to configure bandwidth for the data channel or the control channel. There
is no other specific RSVP configuration needed for this application.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
124
Implementing RSVP for MPLS-TE and MPLS O-UNI
Purpose
Enters RSVP configuration mode.
Enters interface configuration mode for the RSVP protocol.
Sets the reservable bandwidth, the maximum RSVP bandwidth
available for a flow and the sub-pool bandwidth on this interface.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.