Configuring An Lmp Neighbor - Cisco CRS Configuration Manual

Implementing GMPLS UNI
Command or Action
Step 4
router-id ipv4 unicast address
Example:
RP/0/RP0/CPU0:router(config-lmp-gmpls-uni)#
router-id ipv4 unicast 10.10.4.4
Step 5 Use the commit or end command.

Configuring an LMP Neighbor

Perform this task to configure an LMP neighbor for a GMPLS UNI tunnel.
SUMMARY STEPS
1. configure
2. lmp
3. gmpls optical-uni
4. neighbor name
5. ipcc routed
6. router-id ipv4 unicast address
7. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Purpose
Configures the LMP unicast router ID for GMPLS.
commit—Saves the configuration changes and remains within
the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing
the configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring LMP for GMPLS UNI
385