Disassembly And Assembly - Pride Mobility Ultimate 3 Owner's Manual

V I I I . D I S A S S E M B LY A N D A S S E M B LY
DISASSEMBLY
You can disassemble the scooter into seven pieces: the seat, the front section, the rear section, the rear shroud, the
basket, and the batteries. See figure 13. Place the scooter in an area where you have sufficient clearance to move
the parts around. You need about 1.5 to 2 meters in all directions. You may need assistance to lift some of the
scooter components. See III. “Specifications” for individual component weights.
WARNING! Lifting weight beyond your physical capability may result in personal injury.
Ask for assistance when necessary while disassembling or assembling your scooter.
BATTERIES
No tools are required to disassemble or assemble your scooter. Always disassemble or assemble your scooter on
a level, dry surface with sufficient room for you to work and move around your scooter. Keep in mind that the
disassembled sections of the scooter take up more floor space than the assembled scooter.
1. Place the manual freewheel lever in the drive (down) position.
2. Coil the charger power lead and store it for future use.
3. Push forward on the seat lock lever to unlock the seat; lift the seat up and off of the scooter.
4. Gently lift the rear shroud off of the scooter.
5. Disconnect the battery strap.
6. Unplug both black and white 2-pin battery harnesses. See figure 14.
7. Unplug the front-to-rear harness. See figure 14A.
WARNING! Failure to unplug both battery harnesses and the front-to-rear harness prior to
separating the front and rear sections could result in permanent damage to the scooter.
Figure 14. Battery Harnesses
32
SEAT
Figure 13. The Ultimate 3-4 Disassembled
FRONT SECTION
BASKET
Figure 14A. Front-To-Rear Harness
Ultimate 3-4/Rev A/July03
REAR SECTION
REAR SHROUD