Pride Mobility Ultimate 3 Owner's Manual page 34

V I I I . D I S A S S E M B LY A N D A S S E M B LY
ASSEMBLY
1. Position the front and rear sections of your scooter as
shown in figure 19.
2. Align the lower slots of the front section with the cor-
responding pegs on the front of the rear section.
WARNING! Position the front-to-rear
harness cable so it won’t become
pinched between the frame halves
when pivoting the rear section forward.
See figure 20.
3. Holding the seat post, slowly pivot the rear section for-
ward until the curved locking brackets are fully con-
nected onto the top rear pegs. See figures 19 and 20.
4. Raise the tiller.
5. Secure the toggle latch. See figure 15.
n Lower the toggle latch buckle.
n Push back on the toggle latch so it locks into place.
6. Connect the front-to-rear harness and both 2-pin,
black and white battery harnesses.
7. Replace the shroud.
8. Replace the seat, and lock it into place.
34
CURVED LOCKING BRACKETS
PEG
Figure 19. Frame Sections
FRONT-TO-REAR HARNESS CABLE
Figure 20. Frame Lockup
Ultimate 3-4/Rev A/July03