Pride Mobility Ultimate 3 Owner's Manual page 39

X I . C A R E A N D M A I N T E N A N C E
CONSOLE, CHARGER, AND REAR ELECTRONICS
n Allow these areas to dry thoroughly if they have been exposed to moisture before operating your scooter again.
FUSE REPLACEMENT
In the event a fuse should cease to work:
1. Remove the fuse by pulling it out of its slot.
2. Examine the fuse to be sure it is blown. See figures 21 and 21A.
3. Insert a new fuse of the proper rating.
WARNING! The replacement fuse must exactly match the rating of the new fuse. Failure
to use properly rated fuses may cause damage to the electrical system and may result in
personal injury.
Figure 21. Working Fuse
REAR LIGHTS
Light bulbs for the rear running lights and turn indicators are easily replaceable.
NOTE: Replacement light bulbs can be purchased from your authorised Pride Provider.
Use only 24-volt light bulbs.
1. Remove the light cover.
2. Gently remove the bulb by pulling it straight out.
3. Insert a new 24-volt, 5-watt bulb.
4. Replace the light cover.
STORING YOUR SCOOTER
If you plan on not using your scooter for an extended period of time, it is best to:
n Fully charge its batteries prior to storage.
n Disconnect the batteries from the scooter.
n Store your scooter in a warm, dry environment.
n Avoid storing your scooter where it will be exposed to temperature extremes.
WARNING! Always protect batteries from freezing temperatures and never charge a frozen
battery. This damages the battery and can cause personal injury.
For prolonged storage, you may wish to place several boards under the frame of your scooter to raise it off of the
ground. This takes the weight off the tyres and reduces the possibility of flat spots developing on the areas of the
tyres contacting the ground.
Ultimate 3-4/Rev A/July03
Figure 21A. Blown Fuse (Replace)
39