Table of Contents
Advertisement
You can find the current operating software and the software "BE-Flash" on the
website "www.triax.com".
The FM amplifier CGA 225 is designed exclusively for use in the CSE 2800
head-end station.
3
Installation
Caution
– Ensure the head-end station is mounted so it will not be able to vibrate.
Avoid, for example, mounting the head-end station onto a lift shaft or any
other wall or floor construction that vibrates in a similar way.
– Before installing or changing a module, switch off the head-end station or
unplug the power cable from the mains power socket.
Take measures to protect against ESD!
3.1 Installing the FM amplifier
Caution
– When installing a module, make sure that it is inserted in one of the long,
numbered grooves in front of the contact strip on the board at the rear wall
of the housing.
– The shorter, non-numbered grooves without a contact strip on the board at
the rear wall of the housing are for add-on modules only.
• Open the housing of the head-end station in accordance with the assembly
instructions for the CSE 2800.
• Open the locking device
• Insert the FM amplifier in grooves
gently slide it into the head-end station until it makes contact with the board
on the rear wall.
1
in the direction of the arrow (fig. 1).
Fig. 1
A
and
- 5 -
- 5 -
B
of an open slot (fig. 2) and
Advertisement
Table of Contents
