Figure 11. Recovery Boot Jumper - Intel SE7520BD2 User Manual

Server Utilities
3. Insert the Crisis Recovery Diskette into the A: diskette drive.
4. .Plug the system into the AC power source and power it on.
5. A blue screen will be displayed and the recovery process will automatically run. The system
will continue to beep throughout the recovery process.
6. A series of three beeps and no disk access signals the need to insert disk two.
7. When the beeping stops and disk access stops on disk two the recovery process is complete.
8. Remove disk two.
9. Power down and unplug the system from the AC power source.
10. Remove the BIOS recovery jumper at J4H1.
11. Plug the system into the AC power source and power it up to confirm that the recovery was
successful.
Intel® Server Board SE7520BD2
RECOVERY
BOOT
J4H1
J4H3
PASSWORD
CLEAR

Figure 11. Recovery Boot Jumper

FRB
HALT
3
J4H2
TP00902
23