Extended Run Time; Intrusion Codes Via Led Light; Car Finder; Temperature Request (If Acc Temp 101 Installed) - Directed Electronics SmartStart User Manual

1-way remote
a. Rapidly press AUX twice. While the remote's LED is flashing, press and hold
parking lights flash for 2 seconds, pause, and then flash once.
To verify whether the system is in cold weather mode:
The icon should appear on your remote display.
OR
Press the brake pedal:
If the vehicle is in cold weather mode, the parking lights will remain ON while the brake pedal
is pressed. (Automatic transmission ONLY)

Extended Run Time

While the vehicle is running remotely, press and hold the
This will reset the run time counter to zero and restart the run time cycle from the beginning
Note: The extended run time procedure can only be carried out once per remote start.
To stop the vehicle, at any moment, simply press and release the
Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle has
been running for 2 minutes already, pressing the
the engine to run for another cycle (in this case, 3 minutes).

Intrusion Codes via LED light

The system monitors the following:
x
Any vibrations sensed by the shock sensor such as someone breaking of the window,
windshield, etc.
x
Doors
x
Ignition
x
Trunk
x
Hood
Note: If an intrusion has occurred, the siren will sound for a maximum of 60 seconds.
When an intrusion has occurred, pressing
LED will provide an intrusion code corresponding to the type of the intrusion that occurred. The
LED intrusion codes are flashed in continuous loops.
2x = Doors intrusion
3x = Shock Sense
4x = Hood

Car Finder™

When enabled, the Car Finder™ option will help you locate your vehicle by sounding a siren or the
horn. To initiate,
1. Through advance function remote's menu (page-6), select L-01.
2. Press to sound the siren once without affecting the door.

Temperature Request (If ACC Temp 101 installed)

The user can request the temperature in the vehicle if a Temperature Sensor Module (ACC-Temp-
101) is installed:
x
Through the remote's advanced function menu (page-6), select L-01.
x
Immediately press the button and hold it until the temperature is displayed on the
LCD screen.
P.16
until the
button until the remote beeps 3 times.
button.
button will reset the counter to zero and allow
will make the siren chirps four times. The antenna's
5x = Panic
6x = Ignition
7x = Trunk
User Guide