Remote Starting Your Vehicle; Setting Your Vehicle In To Ready Mode - Directed Electronics SmartStart User Manual

and press , then set the minutes and press
Temperature display
TEMP
Can be set to read the temperature in Celsius (CTEMP) or Fahrenheit (FTEMP)
(10)
Language display
LANGU
Can be set to either English or French
(11)
Side button function:
The side button can be programmed as:
Panic button;
x
SBPRO
Stop button;
x
(12)
Temperature request button;
x
Aux 2 output button;
x
x or CWM.
Keypad lock
Note: In order for this feature to work, "Secure function" must be set to ON.
KEYLOC
If there is no activity within the programmed time, the keypad will automatically lock
(13)
after 5 seconds, 10 seconds or 20 seconds.
Press
x
LCD illumination:
ILLUM
When this function is enabled, the LCD will illuminate each time Lock, Unlock or
(14)
START is activated.
Button Function:
The order of LEVELS and MENU can be re-arranged using the
Menu.
F Button Function
FBPRO
Menu
(15)
M 1 2 3
1 2 3 M
Function Button
2 3 1 M
programming
2 1 3 M
3 1 2 M

Remote Starting Your Vehicle

Setting Your Vehicle in to Ready Mode

If your vehicle has a manual transmission you must read the following indications. The unit must
first be set to Ready Mode in order to start the vehicle by remote. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on the
option that was selected by your installer. Therefore, you must follow the appropriate procedure
between the two described below in order to set your vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the IGNITION ON
(RUN) position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
User Guide
.
for about 1sec to unlock the transmitter's keypad.
,
Button Function
FBPRO Function Button Programming
MENU, level 1, level 2, level 3
Level 1, level 2, level 3, MENU
Level 2, level 3, level 1, MENU
Level 2, level 1, level 3, MENU
Level 3, level 1, level 2, MENU
If Ready Mode is enabled by handbrake
P.9