Table of Contents
Advertisement
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as
that used for Ready Mode (page-9); at the last step, press the
the system and leave the engine running.
NEW FEATURE – Push-To-Start Idle Mode
This feature is a variation of "Idle mode", but made specifically for Push-To-Start vehicles, with
automatic or manual transmissions. (Consult your installer for availability of this feature.) Follow the
same steps as the normal Idle Mode procedure, except for when re-entering the vehicle while the
engine is running;
1.
Press unlock
2.
Open then close all doors.
3.
You have 1.5 minutes (or 3 minutes) to press on the brake pedal, to get in gear and
drive off.
Note 1: Pressing on the brake pedal after the allocated (1.5 or 3-min.) period will shut the engine
down.
Note 2: The engine will continue running until the user re-enters the vehicle or until the expiration
of the run time.
Note 3: If the pre-programmed run-time expires or if the user shuts down the engine remotely, the
vehicle will enter Ready Mode automatically (manual transmissions only).
Caution!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
Valet Mode
When the vehicle is in Valet Start mode and Combo Valet mode, the remote starter is disabled. If
the vehicle needs to be serviced, or if you park it indoors, Valet Start mode or the Combo Valet
mode will prevent the engine from being remote-started accidentally.
There are 3 types of Valet Modes: Combo Valet, Valet Start and Valet Alarm.
Valet Start: Only the starter function is disabled.
Valet Alarm: Only the alarm functions are disabled.
Combo Valet: Both remote starter and alarm are disabled.
To put the system into Combo Valet
Shortcut version:
Using the KEY (Ignition Valet Mode):
i)
Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the
IGNITION/RUN and OFF positions 5 times until the parking lights flash 3 times.
ii)
Turn the ignition OFF.
iii)
The LED on the antenna will stay ON indicating that the vehicle has successfully entered
Combo Valet.
iv)
The
icon will appear on the LCD remote.
Using the TRANSMITTER (Remote Valet Mode):
i)
Press the
and
buttons simultaneously until the
display.
ii)
The LED on the antenna will stay ON indicating that the vehicle has successfully entered
Combo Valet.
Using the PUSH-BUTTON SWITCH (Valet Switch Mode):
i)
Insert the ignition key into the ignition switch and turn the key to the ON position
ii)
Within 5 seconds, press the push-button switch until the parking lights flash 3 times.
iii)
Release the push-button and turn the ignition to the OFF position.
User Guide
button to lock the doors, arm
icon appears on the LCD
P.13
Advertisement
Table of Contents
