Taking Pictures Using The Lcd Monitor - FujiFilm MX-1200 Owner's Manual

TAKING PICTURES USING THE VIEWFINDER
5
Beep
Press the shutter button down half way. If the
green viewfinder lamp stops flashing and
remains lit, the camera is focused.
To take the picture, press the shutter button
down fully without lifting your finger off it. The
camera beeps and takes the picture, and the
data is then recorded.
!
While the image data is being recorded, the
viewfinder indicator turns orange and you cannot
take pictures. Do not switch the camera off or open
the battery cover or slot cover during data recording.
!
The viewfinder lamp flashes orange while the flash is
24
charging.
( POWER-SAVING MODE )
Viewfinder Lamp Display
Color Status Meaning
Lit Ready to shoot
Green
AE in progress or camera shake
Flashing
warning
Image being recorded onto the
Lit SmartMedia or battery charging in
Orange
progress
Flashing Flash charging
SmartMedia warning
No SmartMedia
SmartMedia not formatted,
incorrect format, write-protect
sticker used, SmartMedia full,
Red Flashing
SmartMedia error,
charging error
When the LCD monitor is
switched on, details of the
warning are displayed on the
monitor ( P.74).

TAKING PICTURES USING THE LCD MONITOR

1
Set the mode dial to "
Press the "DISP" button to switch the LCD
monitor ON.
loaded,
battery
!
If the date/time display on the LCD monitor is
blinking, set the date and time. ( P.18)
!
Check that the lens is clean. If it is dirty, clean the
lens as described on P.69.
2
Loop the strap over your wrist and hold the
".
camera firmly with both hands so that the LCD
monitor is directly in front of you.
!
The image will be blurred if the camera moves when
you take the picture (camera shake).
2
25