Warning Displays - FujiFilm MX-1200 Owner's Manual

Warning Displays

The table below lists the warnings that are displayed on the LCD monitor.
Explanation
Warning Displayed
The camera battery is low on charge.
No SmartMedia is loaded, or it is loaded
incorrectly.
The SmartMedia is not formatted.
• The SmartMedia contact area are soild.
• The SmartMedia is damaged.
• The SmartMedia format is incorrect.
The SmartMedia is fully recorded.
The SmartMedia is write-protected.
An attempt was made to playback
incorrectly recorded data.
An attempt was made to playback a
frame not recorded on camera.
74
Remedy
Replace or recharge the battery.
Load a SmartMedia or reload the SmartMedia
the correct way round.
Format the SmartMedia.
Wipe the contact area on the SmartMedia with a
soft dry cloth. It may be necessary to format the
SmartMedia. If the error message is still
displayed, replace the SmartMedia.
Erase some images or use a SmartMedia that
has ample free space.
Use a SmartMedia that is not write-protected.
Images cannot be played back.
Images cannot be played back.
Explanation Warning Displayed
The frame number has reached 999-
9999.
There is a strong likelihood of camera
shake because the shutter speed is slow.
A protected frame was erased.
The file has DPOF settings.
The DPOF file contains an error.
Alternatively, the DPOF file was set up
on a different device.
Prints were specified for more than 999
frames in the DPOF frame settings.
An attempt was made to resize an image
not recorded at 1280 960 pixels.
The image may be overexposed in Slow
AE
Synchro flash mode.
Remedy
Switch the Frame No. Memory function off and
use a formatted SmartMedia to take the picture.
If you continue to use the Frame No. Memory
function, images will be recorded beginning from
frame number 100-0001. Take one picture and
then switch the Frame No. Memory function on.
Set the flash to Forced Flash mode or use a
tripod.
Remove the protection.
Cancel the DPOF settings. The protection can
then be removed.
Press the MENU/EXE button to create a new
DPOF file and specify all the DPOF settings
again.
The maximum number of frames for which prints
can be specified on the same SmartMedia is 999.
The image cannot be resized.
Set the flash to a mode other than Slow Synchro.
75