MASTER PROGRAMMING MODE
continued
5.
Press the Extra Cycle button. Use this display to set the Unit
system media. Enter the capacity of the media bed in grains
of the screen. The Unit Capacity parameter is only available
if the control type has been set to one of the metered options.
Use the Up and Down buttons to adjust the value as needed.
Range: 1-9,999,000 grain capacity
6.
Press the Extra Cycle button. Use this display to set the
Feedwater Hardness. Enter the feedwater hardness in grains
corner of the screen. The feedwater hardness parameter is
only available if the control type has been set to one of the
metered options. Use the Up and Down buttons to adjust the
value as needed.
Range: 1-199 hardness
7.
Press the Extra Cycle button. Use this display to set the Safety
Factor. Use this display to select the type of reserve to be used
left-hand corner of the screen. The reserve selection parameter
is only available if the control type has been set to one of the
metered options. There are two possible settings.
SF
rc
cr
Safety Factor
Fixed Reserve Capacity
Variable Reserve
8.
Press the Extra Cycle button. Use this display to set the
system capacity will be held as a reserve. Since this value is
expressed as a percentage, any change to the unit capacity
or feedwater hardness that changes the calculated system
capacity will result in a corresponding change to the reserve
hand corner of the screen. Use the Up and Down buttons to
adjust the value from 0 to 50% as needed.
Range: 0-50%
9.
Press the Extra Cycle button. Use this display to set the
be held as a reserve. The reserve capacity cannot be set to a
value greater than one-half of the calculated system capacity.
if the unit capacity or feedwater hardness are changed. This
of the screen. Use the Up and Down buttons to adjust the
value as needed.
Range: 0-half the calculated capacity
10.
Press the Extra Cycle button. This setting is for a variable
volume remaining when the unit starts regeneration.
11.
Press the Extra Cycle button. Use this display to set the Day
between regeneration cycles. If the system is set to a timer-
type control, the day override setting determines how often
the system will regenerate. A metered system will regenerate
regardless of usage if the days since last regeneration cycle
equal the day override setting. Setting the day override value
by "DO" in the upper left hand corner of the screen. Use the Up
and Down buttons to adjust the value as needed.
Range: Off-99 days