DIAGNOSTIC PROGRAMMING MODE
FR
Flow Rate
PF
Peak Flow
Rate
HR
Hours in
Service
VU
Volume Used
RC
Reserve
Capacity
SV
Software
Version
1.
while in service.
2. Use this display to view the current Flow Rate. This option
the screen.
3. Press the Up button. Use this display to view the Peak Flow
Rate since the last regeneration cycle. This option setting
screen.
4. Press the Up button. Use this display to view the Hours
in Service since the last regeneration cycle. This option
the screen.
5. Press the Up button. Use this display to view the Volume
Used since the last regeneration cycle. This option setting
screen.
Description
rate measured since the last
regeneration
Displays the total hours that the unit
has been in service
Displays the total volume of water
treated by the unit
Displays the system's reserve
capacity calculated from the system
capacity, feedwater hardness, and
safety factor
Displays the software version
installed on the controller
6. Press the Up button. Use this display to view the Reserve
upper left hand corner of the screen.
7. Press the Up button. Use this display to view the Software
left hand corner of the screen.
8. Press the Extra Cycle button to end Diagnostic
Programming Mode.