With A Stud Or A Post - SMA SUNNY BOY 3000-US Installation Manual

5 Mounting
5.4 Mounting the Wall Mounting Bracket on a Wooden Wall with
a Stud or a Post
Additional required mounting material (not included in the scope of delivery):
☐ 3 screws suitable for the foundation.
☐ 3 washers suitable for the screws.
1. Position the wall mounting bracket at the installation location. Tip: The bottom end of the wall
mounting bracket reaches approximately to the bottom corner of the inverter.
2. Align the bracket with a spirit level.
3.
Danger to life from electric shock due to damage to electric lines
Electric lines may be located behind the installation points which can be damaged when
mounting the inverter.
• Ensure that no electric lines are located behind the installation points.
4. Use the wall mounting bracket as a template. For this purpose, mark both uppermost oblong
holes and the lowest oblong hole in the center of the wall mounting bracket.
5. Remove the bracket from the wall.
6. Bore drill holes at the markings.
7. Insert screws with washers through the oblong holes
of the wall mounting bracket into drill holes.
8. Tighten the screws. Ensure that no screws are loose.
9. Ensure that the wall mounting bracket is firmly positioned.
30 SB30-40-US-IA-en-33
SMA America, LLC
Installation Manual