Canon EOS 7D Mark II (G) Instruction Manual page 450

83: Custom ControlsN
: Metering and AF start
When you press the button assigned to this function, metering and AF
are executed.
*1:When assigned to the <p> or <A> button,
pressing the <B> button while the setting
screen is displayed will enable you to set the
detailed AF settings. When shooting, pressing the
<p> or <A> button will execute AF as it was
set.
AF start position
When [Registered AF point] is set, you can press the <p> or
<A> button to switch to the registered AF point.
Registering the AF Point
1. Set the AF area selection mode to one of the following: Single-
point Spot AF (manual selection), Single-point AF (manual
selection), AF point expansion (manual selection
expansion (manual selection, surrounding points), or 65-point
automatic selection AF. Zone AF (manual selection of zone) and
Large Zone AF (manual selection of zone) cannot be selected.
2. Select an AF point manually.
3. Hold down the <S> button and press the <U> button. A beep
will sound and the AF point will be registered. If the AF area
selection mode is set to any setting other than 65-point automatic
selection AF, the registered AF point will blink.
When the AF point is registered, the following will be displayed:
• 65-point automatic selection AF:
• Spot AF, 1 pt AF, Expand AF Area: SEL
center)
When registered with SEL
blink.
To cancel the registered AF point, hold down the <S> button and press
the <m> button. The registered AF point will also be canceled if you
select [54: Clear all camera settings].
450
HP (HP: Home Position)
(Center), SEL HP (Off
or SEL HP, the registered AF point will
), AF point