Installation (Base); Setting Up; Wall Mounting - Geemarc ClearSound Amplidect COMBI355 User Manual

INSTALLATION (BASE)

Setting Up

Connect one end of the curly cord to the handset. The other end
of the curly cord plugs into the jack on the left hand side of the
TM
AMPLIDECT COMBI355. Place the handset on the cradle.
Connect the line cord to the socket located at rear of telephone
then connect the plug into the wall socket **.
Connect the power adaptor to the jack located at the rear of the
telephone then plug the other end into a 13amp wall socket (*).
Please choose a socket near your telephone to enable you to
unplug the mains power quickly in case of a problem.
(*) Classified "hazardous voltage" according to EN60950 standard
(**) Classified TNV-3 according to EN60950 standard.

Wall Mounting

Slide the handset hanger tab out and reverse its position (rotate it
180 degrees). Slide it back into place so that the hook points up
(see diagram 1). This will keep the handset from falling out of the
cradle when it is mounted on the wall.
Knock two self-tapping screws (not supplied) into a wall at a
distance of 80 mm from each other and placed in a vertical line.
Place the phone onto the screw-heads and slide down to secure
(see diagram 2).
Diagram 2
Diagram 1
21