Sherwood RX-4209 Operating Instructions Manual page 14

Tuning to preset stations
1.
After selecting the tuner as an input source, select the preset mode.
2.
Select the desired preset number.
Listening to FM stereo broadcasts
Scanning preset stations in sequence
• Then "PRESET" lights up.
• When using the NUMERIC buttons on the
remote control.
Examples) For "3" :
For "15" :
For "30" :
• When selecting the desired preset number
with the NUMERIC buttons, the desired preset
station will be tuned to automatically without
selecting the preset mode.
• When pressing the PRESET UP/DOWN (▲/▼)
buttons, you don't need to select the preset
mode on the step 1.
• While listening to FM broadcasts, press the
MONO/STEREO button.
• Each time this button is pressed, the FM mode
changes as follows:
Stereo mode : "FM ST" lights up.
Mono mode : "FM MONO" lights up.
• When FM stereo broadcasts are poor because
of weak broadcast signals, select the FM mono
mode to reduce the noise, then FM broadcasts
are reproduced in monaural sound.
• The "PRESET" flickers and then receiver
will start scanning the stations in the preset
sequence and the tuned stations are received
for 5 seconds respectively and other stations are
skipped.
• At the desired station, press this button again to
stop scanning.
14