Sherwood RX-4209 Operating Instructions Manual page 13

Auto presetting
• Auto presetting function automatically searches for FM stations only and store them in the memory.
• While listening to radio broadcasts, press and hold down the MEMORY button for more than 2 seconds.
Manual presetting
• You can store up to 30 preferred stations in the memory.
1.
Tune in the desired station with auto or manual tuning.
2.
Press the MEMORY button.
3.
Select the desired preset number (1~30) and press the MEMORY button.
4.
Repeat the above steps 1 to 3 to memorize other stations.
▄ MEMORY BACKUP FUNCTION
The following items, set before the receiver is turned off, are memorized.
• INPUT SELECTOR settings
• Preset stations, etc.
▄ Note
• If the electricity fails or the AC input cord is disconnected for more than a week, they are all cleared.
So you should memorize them again.
• Then "AUTO MEM" flickers and this receiver
starts auto presetting.
• To stop auto presetting, press this button again.
• Up to 30 FM stations can be stored.
▄ Note
• FM stations of weak strength cannot be memorized.
• To memorize AM stations or weak stations,
perform "Manual presetting" procedure with
using "Manual tuning" operation.
• "MEM" is flickering for 5 seconds.
• When using the NUMERIC buttons on the
remote control.
Examples) For "3" :
For "15" :
For "30" :
• The station has now been stored in the memory.
• When using the NUMERIC buttons, the station
is stored automatically without pressing the
MEMORY button.
• A stored frequency is erased from the memory
by storing another frequency in its place.
• If "MEM" goes off, start again from the above
step 2.
13