Sherwood RX-4209 Operating Instructions Manual page 11

9.
At the desired tone mode, adjust the tone as desired.
Adjusting the sound volume balance
10.
Enter the balance mode.
11.
Adjust the sound volume balance between the left and right speakers.
• If the tone display disappears, start from the
step 8 again.
• When pressing the TREBLE UP/DOWN (+/-) or
BASS UP/DOWN (+/-) buttons, you need not
select the desired tone mode on the step 8.
• The tone level can be adjusted within the range
of -10 ~ +10 dB.
• While displaying "TON CTRL", if the ADJUST
UP/DOWN knob is rotated, "TON DIR" will be
displayed, and vice versa.
• "TON DIR" is displayed, "DIR" lights up and the
sound that bypasses the tone circuitry will be
heard.
▄ Note
• Extreme settings at high volume may damage
your speakers.
• In general, the bass and treble levels are
adjusted to 0 dB.
• "BAL" and the balance level is displayed for 3
seconds.
• If the balance display disappears, start from the
step 10 again.
• When pressing the BALANCE L/R buttons, you
need not select the balance mode on the step 11.
• The balance level can be adjusted within the
range of L10 ~ R10 dB.
▄ Note
• In general, the balance level is set to 0 dB.
11