Sherwood RX-4209 Operating Instructions Manual page 10

4.
Operate the selected component for playback.
5.
Adjust the volume to a comfortable listening level.
6.
To mute the sound.
7.
To listen with the headphones.
Adjusting the tone(bass and treble)
8.
Enter the tone mode.
• "MUTE" flickers.
• To resume the previous sound level, press this
button again.
• When adjusting the volume, the muting effect is
turned off.
• Be sure to switch off both A and B speakers.
▄ Note
• Be careful not to set the volume too high when
using headphone.
• Each time this button is pressed, the
corresponding tone mode is selected and shown
for 3 seconds as follows:
BASS
▄ Note
• When the tone direct function is activated, the
tone mode cannot be entered and "TON DIR"
flickers for 3 seconds.
10
TRBL TON CTRL