Resetting The Factory Defaults: All Application Work Groups - Honeywell Xenon 1900 User Manual

Group 6
Resetting the Factory Defaults:
All Application Work Groups
The following bar code defaults all of the work groups to the factory default set-
tings.
To see what the factory default settings are, refer to the table of
Commands, beginning on page 11-5. The standard product default settings for
each of the commands are indicated by an asterisk (*).
Note: Scanning this bar code also causes both the scanner and the base or
Access Point to perform a reset and become unlinked. The scanner must
be placed in the base, or the Access Point linking bar code must be
scanned to re-establish the link. Refer to
additional information.
If your scanner is in multiple scanner mode, you will hear up to 30
seconds of beeping while all scanners are relinked to the base or Access
Point and the settings are changed.
PAPDFT&
Factory Default Settings:
All Work Groups
Group 5
Menu
Scanner Modes, page 3-13 for
3 - 29