Oki C9600 Service Manual page 182

Display Cause
Open cover Paper jam
Paper Jam detected in fuser
Top cover or between fuser
and paper output
Please see area.
HELP for details
Open cover Paper jam
Paper Jam detected when
Top cover paper started to
enter double-side
Please see printer unit.
HELP for details
Open cover Some sort of jam
Paper Jam occurred in paper
Side cover feed route.
Please see
HELP for details
Open cover Paper jam detected
Paper Jam between cassette
COVER and black ID.
Please see
HELP for details
Check paper Printer engine detects
Paper size error paper that is
TRAY abnormal (45mm or
more) according to
Please see setting.
HELP for details
Change Toner One of the toners
COLOR are almost empty.
Please see
HELP for details
Remove Paper Paper Output
Stacker Stacker is Full
Please see
HELP for details
Insert paper Specified Cassette
MP Tray is Out-Of-Paper or
MEDIA SIZE removed. Or the
cassette used in
Please see the printing process
HELP for details is out-of-paper.
Insert paper Cassette 1, 2, 3,
TRAY 4or 5 has been
MEDIA SIZE detected to be Out-
Of-Paper
Please see
HELP for details
Fuser Counter
Replace Fuser Exceed Life
Paper Near-End
Tray*Paper Detection
Almost Finished
File system Cannot write to
access error HDD.
<n>
42930511TH Rev. 2
Table 7-1-1 Operator Alarm (8/10)
Error Description and Analysis
1) Check for paper jam inside the
fuser and between the Yellow
ID and fuser.
2) Check if the paper output
switch is normal.
Check the entrance or inside the
double-side printer for paper jam.
JAM CHECK
1) Check for paper jam around
the cassette and between the
Yellow ID.
2) Check to see if the paper
entry switch is normal.
1) Is the paper a custom size?
2) Is the paper a standard size?
1) The specified toner cartridge is
almost empty.
2) Check to see if the specified
toner sensor is normal.
1) Check if the stacker is full.
2) Check if the Stacker Full
Sensor activator is normal.
1) Check if MT is Out-Of-Paper.
2) Check and see if the out-of-
paper sensor activator is
normal.
1) Check and see if the specified
cassette is out-of-paper.
2) Check and see if the out-of-
paper sensor activator is
normal.
1) Is an Error message displayed?
2) Is this immediately after the fuser
unit was replaced?
Is the tray paper level low? (less
than about 30 sheets)
Is there any error in the opera-
tional procedures?
Oki Data CONFIDENTIAL
Remedy
judgment
Yes Remove the paper jam.
No Replace paper output switch.
Yes Remove the paper jam.
No Check/replace double-side printer
unit.
Yes Remove the paper jam.
Yes Remove the paper jam.
No Replace the entry switch.
Yes Remedy Unnecessary
Yes Adjust the cassette paper size
guide.
No Paper Size Switch Replace.
Yes Replace with a new toner kit.
No Replace the specified toner sensor.
Yes Remove paper from stacker.
No Replace the Stacker Full Sensor.
Yes Put paper in MT.
No Replace Out-Of-Paper Sensor.
Yes Put paper in specified cassette.
No Replace the corresponding out-of-
paper sensor.
Yes Check the Fuser Unit Life
No Replace the fuser immediately or at
the next maintenance.
Yes Refill with paper.
No Check Paper Near-End Sensor
No Check the manual usage proce-
dures.
Yes HDD malfunction.
Replace HDD.
600 1200
 
 
 
 
 
 
 
 
 
 
 
 
182 /