Default Settings - SATO M-8485Se Operator's Manual

Section 3. Configuration

DEFAULT SETTINGS

SWITCH SELECTIONS
All switches are placed in the Off default position for shipping. This will result in the
following operating configuration:
Communications:
Protocol:
Sensor:
Receive Buffer:
Mode:
Label Sensor:
Backfeed:
External Signals:
SOFTWARE DEFAULT SETTINGS
The printer stores the software settings upon receipt and uses them until they are
again changed by receipt of a command containing a new setting. These settings are
stored in non-volatile memory and are not affected by powering the printer off. The
printer may be reset to use the default software settings by depressing the LINE and
FEED keys simultaneously while powering the printer on. This will result in the
following default configuration:
Print Darkness
Print Speed
Print Reference
Zero
Auto On Line
Once the default operation is completed, a DEFAULT COMPLETED message will be
displayed on the LCD panel. The printer should be powered off while this message is
being displayed (or after the beep is heard. This saves the default settings in the
non-volatile memory where they will be automatically loaded the next time the
printer is powered on.
Page 3-6
8 data bits, no parity, 1 Stop bit, 9600 Baud
Ready/Busy
Gap Sensor
Multi Job
Batch/continuous
Sensor Used
Enabled
Enabled
M-8459Se M-8460/8465Se
3 2
4 in. per sec. 6 in. per sec.
Vertical = 0000, Horizontal = 0000
DEFAULT
COMPLETED
M-8485Se
2
6 in. per sec.
Slash
Enabled
SATO "Se" Print Engines
M-8490Se
2
6 in. per sec.