SATO M-8485Se Operator's Manual page 32

Section 3. Configuration
Stop Bit Selection (DSW1-4). Selects the number of stop bits to end each byte
transmission.
DSW1-4
Baud Rate Selection (DSW1-5, DSW1-6). Selects the data rate (bps) for the
RS232 port.
DSW1-5
Protocol Selection (DSW1-7, DSW1-8). Selects the flow control and status
reporting protocols. See Section 6: Interface Specifications for more information.
(* Will select the Status 2 protocol if DSW2-8 is ON)
DSW1-7
Printer Set Up
Print Mode Selection (DSW2-1). Selects between direct thermal printing on
thermally sensitive paper and thermal transfer printing using a ribbon. Note: This
switch is not used on the M-8459S.
DSW2-1
Sensor Type Selection (DSW2-2). Selects between the use of a label gap or a
reflective Eye-Mark detector. See page 2-9 for the location of these sensors.
DSW2-2
Off
On
Page 3-2
SETTING
Off 1 Stop Bit
On 2 Stop Bits
DSW1-6 SETTING
Off Off 9600
Off On 19200
On Off 38400
On On 57600
DSW1-8 SETTING
Off Off Rdy/Bsy
Off On Xon/Xoff
On Off Bi-Com 3
On On Bi-Com 4*
SETTING
Off Therm Xfr
On Direct Therm
SETTING
Gap
Eye-Mark
DSW1
ON
OFF
1 2 3 4
DSW1
ON
OFF
1 2 3 4
DSW1
ON
OFF
1 2 3 4
DSW2
ON
OFF
1 2 3 4
DSW2
ON
OFF
1 2 3 4
SATO "Se" Print Engines
5 6 7 8
5 6 7 8
5 6 7 8
5 6 7 8
5 6 7 8