Speakers Set - Yamaha RX-V750 Service Manual

5. SPEAKERS SET

• The input signals are automatically judged in the priority
order of DTS DD AAC
• The same signal as the 0dB signal of No.1 DSP THROUGH
is output from the DSP section.
The analog switch settings for each sub-menu are as shown
in the table below.
Sub-menu
1 FRNT: SML 0 dB
2 CENTER: NONE
3 LFE/B: FRNT
4 Pre Mix: 5ch
5 Front GAIN 1
6 Front GAIN 2
7 Znone 2 Amp ON
LARGE: This mode is used with a speaker with high bass repro-
duction performance (a large unit). Full bandwidth signals
are output.
SMALL: This mode is used with a speaker with low bass reproduc-
tion performance (a small unit). The signals of 90Hz or
less are mixed into the channel specified by LFE/BASS.
NONE: This mode is used with no center speaker.
The center content is reduced by 3dB and distributed to
FRONT L/R.
PCM Analog (A/D).
5.FRNT:SML 0dB
5.CENTER:NONE
5.LFE/B:FRNT
5.Pres Mix:5ch
5.Front GAIN 1
5.Front GAIN 2
5.Zone2 Amp ON
CENTER SP SUR SP
LARGE LARGE
NONE LARGE
SMALL SMALL
LARGE LARGE
LARGE LARGE
LARGE LARGE
LARGE NONE
RX-V750/DSP-AX750/DSP-AX750SE
FRONT SP LFE/BASS SUR.B SP
SMALL SWFR LARGE
LARGE SWFR LARGE
LARGE FRONT SMALL
LARGE SWFR LARGE
LARGE SWFR LARGE
LARGE SWFR LARGE
LARGE SWFR NONE/LARGE
RX-V650/HTR-5760
35