5. Operation check of MAIN (1) P.C.B.
o
a. Remove 2 screws (
). (Fig. 12)
* Arrow marks (
) are printed to identify the screws to be
removed.
!0
b. Remove 3 screws (
) and 2 screws (
c. Loosen the harness fixture fixing the cable.
d. Raise the Amp Unit from the front toward the back.
e. Put an insulating sheet under the Amp Unit before per-
forming any checks for proper operation.
When checking the P.C.B.:
• Reconnect all cables (connectors) that have been disconnected.
• When connecting the flat cable, use care for the polarity.
• The P.C.B. removed from the rear panel does not work because
its grounding is loose. Be sure to connect the ground of each
P.C.B. to the chassis or GND with a jumper wire or the like.
9
Fig. 12
o
!0
!1
). (Fig. 13)
10
9
Fig. 14
RX-V750/DSP-AX750/DSP-AX750SE
RX-V650/HTR-5760
!1
11
11
10
Fig. 13
10
23