Install And Configure Is-Soft Application; Configure Pc's Ip Address - Aiphone IS SERIES Quik Start Programming Manual

Step 2:

Configure PC's IP Address

The default IP address for each IS-IP device is https://192.168.0.40. The PC will need to be set in the same subnet in
order to connect to the IS-IP devices.
A. Open Control Panel
- Windows XP (classic view)
®
Connection Status window.
- Windows 7 (Category View)
®
Local Area Connection to open the Local Area Connection Status window.
B. Click the Properties button to open Local Area Connection Properties window.
C. Scroll down and click Internal Protocol Version 4 (TCP/IPv4) then click the Properties button to open Internet
Protocol Properties window.
D. Select the Use the following IP address radio button. Type in the IP address 192.168.0.100 (the last number
can be any valid host address except 40) and change the subnet mask to 255.255.255.0. Click [OK].
E. Click [OK] in the Connection Properties window to accept these changes.
Step 3:
Install and Configure IS-SOFT Application (OPTIONAL)
Note: IS-SOFT is not required to program the system. If using IS-SOFT, the application
requires a PC with speakers and a microphone , or a headset in order to
communicate with the stations in the system.
A USB style microphone / headset is recommended.
A. Click the Setting button and click the Network tab.
B. Enter the Host's IP address, the Connection password "aiphone" and choose the Network Interface Card from
the drop down list. Enter the license key provided in the CD case (limit one per PC).
C. Click Save .
IMPORTANT:
The software will attempt to make contact with the Host, but will give an error message because the Host isn't set
up yet. Ignore this error and proceed to Step 4: Log in to IS-IP Device.
Figure 3.1: IS-SOFT
Note: Please register the IS-SOFT. See Step 12.
Network Connections
Network and Internet
Double click Local Area Connection to open
View network status and tasks
Figure 3.2: Network Tab
Click
How-To
Video Link
3