Installing Expansion Card Risers - Dell PowerEdge R630 Owner's Manual

Figure 33. Removing and installing the expansion card riser 3
1. connector
3. expansion card release latch
2. If applicable, remove or install an expansion card on the riser.
3. Replace the expansion-card riser.
Next steps
Follow the procedure listed in

Installing expansion card risers

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1. If applicable, reinstall the expansion card(s) into the expansion card riser.
2. Align the expansion-card riser with the connector and the riser guide pin on the system board.
3. Lower the expansion-card riser into place until the expansion-card riser connector is fully seated in
the connector.
84
After working inside your
2. expansion card riser 3
system.