Adjusting Sleep Mode; Using Hibernate Mode; Setting Hibernate Timeout - Lexmark XC2130 User Manual

Saving money and the environment
Use
On
Off
3
Click Submit.

Adjusting Sleep mode

1
From the home screen, navigate to:
> Settings > General Settings > Timeouts > Sleep Mode
2
In the Sleep Mode field, select the number of minutes the printer is idle before it enters Sleep mode.
3
Apply the changes.

Using Hibernate mode

Hibernate is an ultra‑low‑power saving mode.
Notes:
• Three days is the default amount of time before the printer enters Hibernate mode.
•
Make sure to wake the printer from Hibernate mode before sending a print job. A hard reset or a long press of
the Sleep button wakes the printer from Hibernate mode.
•
If the printer is in Hibernate mode, then the Embedded Web Server is disabled.
1
From the home screen, navigate to:
> Settings > General Settings
2
Touch Press Sleep Button or Press and Hold Sleep Button.
3
Touch Hibernate >

Setting Hibernate Timeout

Hibernate Timeout lets you set the amount of time the printer waits after a print job is processed before it goes into a
reduced power state.
Using the Embedded Web Server
1
Open a Web browser, and then type the printer IP address in the address field.
.
To
Reduce printer noise.
Notes:
• Print jobs are processed at a reduced speed.
•
Printer engine motors do not start until a document
is ready to print. There will be a short delay before
the first page is printed.
Use factory default settings.
Note: This setting supports the performance
specifications of the printer.
195