Lexmark XC2130 User Manual page 148

Understanding the printer menus
Use
Alarms
Alarm Control
Cartridge Alarm
Timeouts
Standby Mode
Disabled
1–240
Timeouts
Sleep Mode
Disabled
1–120
Timeouts
Hibernate Timeout
Disabled
1–3 hours
6 hours
1–3 days
1–2 weeks
1 month
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Timeouts
Screen Timeout
15–300
To
Set an alarm when the printer requires user intervention.
For each alarm type, select from the following options:
•
Off
•
Single
•
Continuous
Notes:
•
Single is the factory default setting for Alarm Control and
Cartridge Alarm. This sounds three quick beeps.
•
Continuous repeats three beeps every 10 seconds.
Set the amount of time in minutes before the printer enters a lower
power state.
Note: 15 is the factory default setting.
Set the amount of time in minutes the printer waits after a job is
printed before it goes into a reduced power state.
Notes:
• 20 is the factory default setting.
• Lower settings conserve more energy, but may require
longer warm‑up times.
•
Select the lowest setting if the printer shares an electrical
circuit with room lighting or you notice lights flickering in the
room.
•
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm‑up time.
Set the amount of time the printer waits before it enters Hibernate
mode.
Note: 3 days is the factory default setting.
Set the printer to Hibernate mode even if there is an active Ethernet
connection.
Note: Do Not Hibernate is the factory default setting.
Set the amount of time in seconds before returning the control
panel to a Ready state.
Note: 30 is the factory default setting.
148