Program Recording (Cd = Tape) - Kenwood HM-333 Instruction Manual

Program recording
Desired CD tracks can be programmed in the desired sequence and recorded onto a tape.
The tape deck of the unit can record signals only on Normal (Type ) and High (Type ) tapes. It cannot record on
Metal (Type ) tapes.
Be sure to put the cassette deck in stop mode.
1
Make preparation for recording.
1
Select the CD input.
2
Ensure that the "RANDOM" indicators are not lit.
3
Perform steps 1 to 3 of the procedure in "Recording on TAPE". •
4
Insert disc in the CD player.
÷ If the "RANDOM" indicator is lit, turn it off by pressing the RANDOM key to cancel the random play mode.
2
Program the desired sequence of CD tracks.
Perform steps 1 and 2 of the procedure in
"Listening to the desired sequence (Pro-
gram playback)". ⁄
3
Start recording.
TAPE O.T.E.
If you are operating the remote, the same effect
as step 3 can be obtained by simply pressing the
TAPE O.T.E. key to start recording.
To interrupt a recording
(Recording and playback will be stopped)
(CD = TAPE)
7
stop
Tuning
Mode
Convenient recording methods
÷ When the PGM key is pressed to cancel the ed-
ited contents, the entire editing contents will be
¤
erased.
÷ Tracks programmed beyond the available tape recording
time will be interrupted in the middle.
÷ Recording starts from the first track in the pro-
gram and ends after having recorded the entire
programmed tracks.
÷ Recording stops automatically when the program
playback of CD has completed.
÷ When either playback or recording stops, the other op-
eration is stopped automatically.
At the end of the recording
Cassette deck : Stop is executed after an unre-
corded portion of about 4 sec.
has been produced.
37